Let road traffic regulations be your operating manual – Minister

By Yaw Ansah, GNA

Accra, March 15, GNA –
Mr Kweku Ofori Asiamah, the Minister of Transport, has urged newly trained Bus
Rapid Transit (BRT) drivers to be guided by the Road Traffic Regulations to
ensure that road carnage was reduced to its barest minimum.

He told the drivers
to obey the rules and regulations of the governing road transport industry and
put to practice all defensive driving techniques anytime they sat behind the
wheel.

Mr Asiamah made the
call when the Government and Technical Training Centre (GTTC) held a Graduation
Ceremony for 40 newly trained BRT drivers in Accra.

The Ministry, in
collaboration with the Ministry of Local Government and Rural Development and
the Ministry of Roads and Highways, is implementing a programme to introduce
scheduled bus services in some major cities such as Accra, Kumasi,
Sekondi-Takoradi and Tamale.

“Efforts are,
therefore, aimed at promoting higher occupancy bus services in cities to reduce
congestion and its attendant health and socio-economic cost,” he said.

He said due to the
rapid changes that occurred in the transport industry, with the introduction of
new vehicle technology, it was important that drivers were given periodic
training in order to increase their understanding on the vehicles they drove.

Mr Asiamah added that
there were now all sorts of electronic and safety devices embedded in today’s
brands of vehicles, which required adequate technical knowledge and skills to
operate.

He said, drivers,
when equipped with the needed skills and techniques, could lead to increment in
the uptime and enhance the efficiency of the vehicle.

Mr Emmanuel Kwafo
Offei, the Acting Principal of Government Technical Training Centrw, said the
Centre, since its establishment in 1968 as a model Institute following a
Technical cooperative agreement between the Government of Ghana and the Federal
Republic of Germany, operated with unique German methodology.

Currently the Centre,
he said, offered four main technical programmes; Auto Mechanics, Auto Electricals,
Welding and Fabrication, and Auto Body Repairs.

Mr Offei said through
a collaborative effort between GTTC, Scania and GIZ, the Centre had received
tools from GIZ and other electronic equipment, and that it would soon refurbish
the Centre’s workshop into an ultra-modern mechatronic one.

GNA

Credit: Source link

Share:

Leave a Reply